Highly integrable planar-structured printed circularly polarized antenna for emerging wideband internet of things applications in the millimeter-wave band

This paper proposes a numerically and experimentally validated printed wideband antenna with a planar geometry for Internet of Things (IoT) applications. This design tackles the challenges associated with deploying IoT sensors in remote areas or across extensive geographical regions. The proposed design exploits a coplanar-waveguide-fed modified microstrip line monopole for excitation of circularly polarized waves radiating in the broadside direction. The primary design is based on perturbations of the microstrip line protracted from a grounded coplanar waveguide. The capacitively coupled short rectangular stubs are periodically inserted alternately and excited asymmetrically on each side of the microstrip line parallel to the direction of the electric field vector. The sequential phase excitation of the periodic stubs generates a rectangular-cascaded electric field, which suppresses the stop band at the open end. As a result, the antenna radiates in the broadside direction. The impedance bandwidth of the antenna exceeds 8 GHz in the 28 GHz mm-wave band, i.e., it ranged from 25 to 33.5 GHz. Additionally, an axial ratio below 3 dB is achieved within the operating band from 26 to 33.5 GHz with the alterations of the surface current using straightforward topological adjustments of the physical parameters. The average in-band realized gain of the antenna is 10 dBic when measured in the broadside direction. These results indicate that the proposed design has the potential to improve the connectivity between IoT devices and the constantly varying orientation of satellites by mitigating the polarization mismatch.